Rena MACH X (Digital Color Label Printer) - Manual (Page 112)

SECTION 5
TROUBLESHOOTING
106
Toolbox System Status Messages (continued)
Displayed, in
red , in the MC Series Toolbox utility.
SYSTEM STATUS PROBLEM SOLUTION
X_INK_LOW
Example: CYAN_ INK_LOW
X = Color.
One or more Ink Tanks
are low on ink. Ink Tank replacement will be necessary
soon. Reorder Ink
INK_OUT_X
Example: INK_OUT_YELLOW
X = Color or MULTI
One or more Ink Tanks
are out of ink
Replace empty Ink Tank(s).
WARNING! Use proper procedure to
replace Ink Tank(s) to avoid damage.
See “Replacing the Ink Tanks” section.
Press the “Replace Ink Tanks” button,
then verify that Ink Tanks are seated
firmly and latches are fully closed.
Verify that the printer is on a stable,
level surface.
Try to clear the error by pressing
the “Refresh Ink Levels” button,
located in the Toolbox.
MAINTENANCE_BUSY
Printer is performing
maintenance. No action is required. Wait for printer
to finish.
Printer is waiting to
perform maintenance;
if error is shown in
combination with
“Reason: Uncapped
printhead or clamshell
open"
and there is no
maintenance activity
(noise) coming from
printer.
Remove media from print engine. See
“Paperpath_Paperjam” solutions.
If problem continues clean Paperpath
Entry and Exit sensors.
If problem continues contact Service.
CARTRIDGE_MISSING_X X = Color or MULTI
Missing Ink Tank, or Ink
Tank not being
recognized Replace Ink Tank(s) using proper
procedure.
Insert missing Ink Tank.
Clean Ink Tank contacts as outlined in
“Operator Maintenance” section.
Clear error by pressing the “Refresh Ink
Levels” button in the Toolbox.
MECH_FAIL_PERMANENT
Reason: Sled lift failed
Reason: Ink valve failed
Reason: Sled home failed Mechanical failure or
sensor failure. One of
the printer’s mechanical
components was not
properly registered at the
expected position. If the Service Station was just installed;
check to be sure it was installed
properly.
Call for Service Support.