QuickLabel 482 Pronto! User Manual
Page 243
Pronto! 482/486/682/863
16-9
Remove ribbon
Transfer ribbon is loaded
although the printer is set
to direct thermal printing
for direct thermal
printing remove ribbon
for thermal transfer
printing set the printer in
the configuration or in
the software to transfer
printing
Structural err.
Error in directory of the
memory card, non-secure
data access
Reformat memory card.
Unknown card
Memory card not
formatted
Memory card type not
supported
Format card,
use another card type.
USB error
Device stalled
USB device is detected,
but does not function
Do not use USB device.
USB error
Too much current
USB device drawing too
much current
Do not use USB device.
USB error
Unknown device
USB device not
recognized
Do not use USB device.
Voltage error
Hardware error
Switch printer off and on
again.
If it occurs again
→
Service.
The voltage which has
failed is displayed. Please
note this.
Write error
Hardware error
Repeat write attempt.
Reformat card.
Write protected
Write protection of the
PC card is activated.
Deactivate write
protection.
Wrong revision
Error when loading a
new firmware version.
Firmware does not work
with hardware version
Load appropriate
firmware.
Error message
Cause
Error recovery