Insertion of the prepared winding axle, Insertion of the prepared winding axle -34 – QuickLabel 482 Pronto! User Manual
Page 124
8-34
Accessories
Insertion of the Prepared Winding Axle
Unwinding from a roll with outside wound labels
Unwinding from a roll with inside wound labels
•
Hang up the axle with material in the unwinder. When hanging up, the
flange with the knurled screw has to be in front.
•
Feed the label strip (14) over the swing arm (7) and the rewind axle (15) to
the printer.
Note: Pay attention to the different positions of the unwinder. The position
depends on the winding of the material rolls as described in Placing the
Unwinder on page 8-29.
This manual is related to the following products: