Guntermann & Drunck DVICenter DP16 Target Modules and User Modules - Standard Variants - Manual (Page 87)

User module »DP-CON«
Target and user modules · 83
Status displays
Front panel
The LEDs on the front panel of the user module show the system’s operating status.
Section LED Status Meaning
Power Red. On The optional power pack is connected and the required voltage
(12 Volt) is available.
Off The optional power pack is not (properly) connected.
Main On The power pack provides the required voltage.
Off The power button is turned off or the connection with the mains
could not be established.
Check the proper connection of the power supply cable.
Status Trans. On The communication with the matrix switch could be established.
Off The communication with the matrix switch could not be estab-
lished.
System On The device is booting or carries out a firmware update.
Blink-
ing
The system is ready for operation.
Console Video On Stable image signal at video input.
Off The incoming video signal could not be detected or it lacks the
required quality to be processed by the system.
K/M On A local keyboard was found.
Off No power at PS/2 interface or USB bus.
Blink-
ing
The CPU input (PS/2 or USB) is active and ready.
No local keyboard was found.
Trans.
System
Status
Main
Red.
Power
Video
K/M
Service Console