Guntermann & Drunck DVICenter DP16 Target Modules and User Modules - Standard Variants - Manual (Page 33)

Target module »DVI-CPU-Fiber-UC«
Target and user modules · 29
Connection to the matrix switch
Trans. 1|Tx: Insert the LC plug of a compatible optical fibre cable.
Connect the other end of the cable to the Rx interface of a Dynamic Port provided at
the first matrix switch.
Trans. 1|Rx: Insert the LC plug of a compatible optical fibre cable.
Connect the other end of the cable to the Tx interface of the same Dynamic Port pro-
vided at the first matrix switch.
Trans. 2|Tx: Insert the LC plug of a compatible optical fibre cable.
Connect the other end of the cable to the Rx interface of a Dynamic Port provided at
the second matrix switch.
Trans. 2|Rx: Insert the LC plug of a compatible optical fibre cable.
Connect the other end of the cable to the Tx interface of the same Dynamic Port pro-
vided at the second matrix switch.
Power supply
Power In: Connect the cable of the power pack to this interface. Now connect the
power cable to the power pack and a power socket.
The devices use components with laser technology which comply with laser
class 1.
They meet the requirements according to EN 60825-1:2007 and EN 60825-
2:2004+A1:2007 as well as U.S. CFR 1040.10 and 1040.11 .
Mind the following instructions when dealing with laser beams:
 Avoid eye contact with invisible laser beam on page 2
 Always connect optical connections or cover them with protection caps on page 2
 Only use G&D certified transmission modules on page 2
NOTE: Use optical fibres with LC plugs to connect the devices. The cables are avail-
able as accessories.
IMPORTANT: For each matrix switch, connect only one Trans. interface of the tar-
get module!
ADVICE: You can also connect the target module directly to a compatible user mod-
ule.