Guntermann & Drunck DVICenter DP16 Target Modules and User Modules - Standard Variants - Manual (Page 74)

User module »DVI-CON-Fiber«
70 · Target and user modules
Connection to the matrix switch
Transmission |Tx: Insert the LC plug of an optical fibre cable.
Connect the other end of the cable to the Rx interface of a compatible Dynamic Port
provided at the matrix switch.
Transmission|Rx: Insert the LC plug of an optical fibre cable.
Connect the other end of the cable to the Tx interface of the same Dynamic Ports pro-
vided at the matrix switch.
Power supply
Main Power: Connect the power cable with the power pack and a power socket.
Red. Power: Connect the cable of the optional power pack to establish a redundant
power supply. Connect the power cable with the power pack and a power socket of
another power circuit.
Start-up
Turn on the power button of the Main Power power pack.
The devices use components with laser technology which comply with laser
class 1.
They meet the requirements according to EN 60825-1:2007 and EN 60825-
2:2004+A1:2007 as well as U.S. CFR 1040.10 and 1040.11 .
Mind the following instructions when dealing with laser beams:
 Avoid eye contact with invisible laser beam on page 2
 Always connect optical connections or cover them with protection caps on page 2
 Only use G&D certified transmission modules on page 2
NOTE: Use optical fibres with LC plugs to connect the devices. The cables are avail-
able as accessories.
ADVICE: You can also connect the target module directly to a compatible user mod-
ule.
ADVICE: During the System Startup of the suer module. the current hotkey configu-
ration of the matrix switch is shown.