Guntermann & Drunck DVICenter DP16 Target Modules and User Modules - Standard Variants - Manual (Page 45)

Target module »VGA-CPU-UC«
Target and user modules · 41
Installation
Connecting the target computer
Keyb.: Use the purple plug of the Twin-PS/2 cable to connect the computer’s PS/2
keyboard interface to this interface.
Mouse: Use the green plug of the Twin-PS/2 cable to connect the computer’s PS/2
mouse interface to this interface.
USB K/M: Use the USB device cable to connect one of the computer’s USB interfaces
to this interface.
VGA CPU: Use the supplied video cables to connect the computer’s analogue video
output to this interface.
Line In: Use one of the supplied audio cables to connect the computer’s Line Out
interface to this interface.
Line Out: Use one of the supplied audio cables to connect the computer’s Line In inter-
face to this interface.
Connections to the matrix switches
Trans. 1: Connect this interface to a Dynamic Port (RJ45) of the first matrix switch.
Trans. 2: Connect this interface to a Dynamic Port (RJ45) of the second matrix switch.
NOTE: Keyboard and mouse signals can be transmitted to the computer using either
the PS/2 interfaces or the USB interface.
IMPORTANT: Connect only one of the target module’s Trans. interfaces for each
matrix switch!
NOTE: Only use category 5e (or better) twisted pair cables to connect the devices.
ADVICE: You can also connect the target module directly to up to two compatible
user modules.
Mouse Keyb. USB K/M
VGA CPU
Power
Trans. 1 Trans. 2 Service Line In Line Out Power In