Guntermann & Drunck DVICenter DP16 Target Modules and User Modules - Standard Variants - Manual (Page 107)

User module »DVI-CON-Video«
Target and user modules · 103
Start-up
Start the user module by pressing the Main Power button of the power pack.
Status displays
Front panel
The LEDs on the front panel of the user module show the system’s operating status.
ADVICE: The active hotkey configuration is displayed during the System Startup of
the matrix switch.
Section LED Status Meaning
Power Red. On The optional power pack is connected and the required voltage
(12 Volt) is available.
Off The optional power pack is not (properly) connected.
Main On The main power supply provides the required voltage.
Off The power button is turned off or the connection with the
mains could not be established.
Check the proper connection of the power supply cable.
Status Trans. On The communication with the matrix switch could be estab-
lished.
Off The communication with the matrix switch could not be estab-
lished.
System On The device is booting or carries out a firmware update.
Blinking The system is ready for operation.
Console Video On Stable image signal at video input.
Off The incoming video signal could not be detected or it lacks the
required quality to be processed by the system.
Active On A local keyboard was found.
Off No power at PS/2 interface or USB bus.
Blinking The CPU input (PS/2 or USB) is active and ready.
No local keyboard was found.
Trans.
System
Status
Main
Red.
Power Console
Video
Active
Service