Guntermann & Drunck DVICenter DP16 Target Modules and User Modules - Standard Variants - Manual (Page 122)

Configuration
118 · Target and user modules
Resetting the default settings
This setting resets the default settings of the extender mode. All settings that have
been changed by the user are reset.
How to reset the default settings of the matrix switch:
1. Press the Alt+Num (default) hotkey to open the on-screen display.
2. Select Console utility and press Enter .
3. Select Set system defaults and press Enter .
Showing status information
The OSD shows you information about the user module and the connected target
module.
Several menus provide you with the following information:
How to show status information in the OSD:
1. Press the
Alt+Num (default) hotkey to open the on-screen display.
2. Select Information and press Enter .
3. Use the arrow keys to select the desired menu item (see above).
4. Press Enter to show the desired information.
5. Press Esc to leave the menu.
FIRMWARE INFO
This menu shows information about the user module (console) and the target module (target).
ID:
Device ID
Version: Installed firmware version
Device: Type name
Firmware: Name of installed firmware
HOTKEY
Local Hotkey (Modifier+Key)
Modifier:
Modifier key of key combination
Key: Hotkey of key combination
Local OSD via 2x keypress
Modifier:
Configured key to oprn the on-screen display via double keypress
Local selectkeys
Keys:
Selected set of select keys:
HARDWARE INFORMATION
Serial number: Serial number of user module