Gasboy Atlas Fuel Systems Installation Manual - Manual (Page 9)

MDE-4331M Atlas® Fuel Systems Installation Manual · September 2014 Page 1-3
Atlas Model Codes Introduction
Atlas Commercial Mechanical Series
Atlas commercial mechanical series dispensing units are UL-listed and are available in a

self-contained (suction pump) package or remote-controlled (dispenser) package. Both
packages offer a variety of models that are available as single-hose outlets or dual-hose outlets
(with single or dual product capability). Following self-contained models are available:
• Standard speed, up to 15 GPM/56 LPM
• High speed, up to 22 GPM/83 LPM
• As a single-hose model with high capacity speed up to 26 GPM/99 LPM.
Note: DEF unit is a standard speed unit.
The rate of delivery for remote-controlled packages varies based on the size of the submersible
pump and plumbing to the dispenser. The delivery rate of both packages also varies depending
on installation conditions and additional accessories.
All models of the Atlas commercial mechanical series offer mechanical non-computers,
complete with electric resets. Mechanical pump registers display the total volume for a
delivery. All non-computers read up to 999.9 gallons/liters.
Atlas Model Codes
Atlas Model Codes
Digit 1 and 2 3 4 5 6 Pumps 6-8 or
Dispenser 7-9
Product
Series
Model
Type
Flow
Rates
Atlas Pump/Dispenser Hydraulic
Configuration
Product Series
Retail Mechanical 87
Retail Electronic 88
Commercial Mechanical 91
Commercial Electronic 98
Model Type
Super-Hi 4
Standard, High-Flow, Ultra-Hi 5
DEF Dispenser 6
E85 Dispenser 7
Flow Rates
Super-Hi (40 GPM)/Ultra-Hi 
(50 GPM)
0
Standard-Flow (10-15 GPM) 2
High-Flow (18-22 GPM) 3
Atlas Model Designation K
Pump/dispenser
Self-contained Pump Blank
Dispenser X
Hydraulic Configuration
1-Grade, 1-Hose Blank
1-Grade, 2-Hose TW1
2-Grade, 2-Hose TW2
Combo (Ultra-Hi only) TW3