Gasboy Atlas Fuel Systems Installation Manual - Manual (Page 63)

MDE-4331M Atlas® Fuel Systems Installation Manual · September 2014 Page 7-1
Reference Contents Reference Information
7 – Reference Information
This section contains reference information for the contractor. The contractor may or may not
be required by individual contract to perform all or any of the requirements outlined. However,
all installations must conform to the requirements in this section. The information in this
section can be found in detail in MDE-4333 Atlas Fuel Systems Site Preparation Manual.
Note: The information in this section is not to be used exclusively in lieu of MDE-4333 Atlas
Fuel Systems Site Preparation Manual, as not all information contained in that manual
is found here.
Reference Contents
Section and Information Location in MDE-4331
Electrical Requirements page 7-2
Emergency Power Cut-off Switch
Circuit Breakers
STP Control Relay Boxes for Dispensers
STP Isolation Relays for Electronic Dispensers
Conduit page 7-3
Wiring page 7-4
Retail Data Wire Lengths
Grounding page 7-6
Sealing ‘Y’ Fittings page 7-7
Plumbing Requirements page 7-8
Pipe Installation
Pipe Size
Pumps (Standard Flow)
Pumps (High Flow, Super-Hi, Ultra-Hi)
Dispensers (Standard Flow)
Dispensers (High Flow, Super-Hi, and Ultra-Hi)
Check Valves page 7-10
Shear Valves