Gasboy ATC M05819K00X Kits - Manual (Page 20)

Installing the Commercial Atlas (9800K) ATC Kits
Page 20 MDE-4431C Gasboy ATC M05819K00X Kits Installation Manual · February 2013
3 Peel the protective cover from the Mounting Sponge (on the back of the Polycase Box) and
mount the box as shown in
Figure 12 . Mount about 1-1/2 inches up from shelf.
Figure 12: Mounting the Polycase Box (LP-70)
About

1-1/2 inches
Clearance
4 On the two shelves creating the air gap, locate the two washers [N23746-01 (mounted to shelf
with two screws)].
Note: The lower washer location also has a Gasket (N23761-04).
5 Remove the two screws from each washer and remove the washers. Retain the gasket and
screws to use later.
6 Locate the two Conduit Seal Washers (N23760-07) provided in the kit.
7 Place the two conduit seal washers where the two Washers (N23746-01) were mounted, place
the gasket (saved in step
5 ) under the conduit seal washer on the lower shelf, and secure
washers with screws removed in step 5 .
8 Locate the Single IS Barrier (27913) and Dual Probe Connector Assembly (212AY05)
provided in the kit. Remove the nut and washer from the mounting stud on the IS Barrier and
slide them off the wires. Retain the nut and washer to use later.