Gasboy ATC M05819K00X Kits - Manual (Page 12)

Installing the Commercial Atlas (9800K) ATC Kits
Page 12 MDE-4431C Gasboy ATC M05819K00X Kits Installation Manual · February 2013
9 Feed the wires extending from the IS Barrier Mounting Stud through the Conduit Seal Washer
on each shelf as shown in
Figure 4 and place the mounting stud through the holes.
Figure 4: Mounting the IS Barrier on the Shelf
IS Barrier
IS Barrier Mounting
Stud through Air Gap
Lower Conduit Seal
Washer and Gasket
Upper Conduit
Seal Washer
10 Place the wires extending from the mounting stud through the mounting hole in the single
Probe Connector Assembly and place the assembly up on the stud (under the shelf as shown in
Figure 5 ).
Figure 5: Probe Connector Assembly and IS Barrier Stud Mounting (Under the Shelf)
Probe Connector
Probe Connector
Assembly
IS Barrier
Mounting Stud
11 Place the washer and nut over the wires and turn nut onto the stud securing the IS Barrier and
Probe Connector. Tighten snugly but do not overtighten.