Gasboy ATC M05819K00X Kits - Manual (Page 10)

Installing the Commercial Atlas (9800K) ATC Kits
Page 10 MDE-4431C Gasboy ATC M05819K00X Kits Installation Manual · February 2013
Installing the Commercial Atlas (9800K) ATC Kits
Installing the ATC M05819K001 or M05819K003 Kit in Single Unit
Preparing for Installation
Request permission from the manager/owner to remove power from the unit and then remove
power using normal procedures. Observe the lockout/tagout safety procedures.
Ensure that you have the proper kit for the model dispenser to be retrofitted.
To install the ATC M05819K001 or M05819K003 Kit in Single Unit, proceed as follows:
1 Using the proper key for the unit, unlock and remove the doors from both sides of the unit.
Note: Place doors in a safe place to prevent damage or scratches.
2 Remove the two screws securing the dial-enclosure assembly using a Phillips screwdriver and
remove the assembly. Retain the screws for the replacing assembly after installation.
3 Remove the two screws at side 1 of the unit (located above the display) using a Phillips
screwdriver, and pull the display cover forward.
Note: The cover pivots down in a horizontal position to allow access to the electronics section
of the unit. Save screws for replacing the assembly after installation.
Installing the ATC Kit
To install the ATC Kit, proceed as follows:
1 Locate the Polycase Box (LP-70) with SK449C mounted inside the M05819K001 Kit.

~OR~

Locate the Polycase Box (LP-70) with Printed Circuit Board [PCB (28017)] mounted inside
M05819K003 Kit.
2 Remove the four mounting screws securing the cover and remove the cover from the box.
Retain the screws and cover for reinstalling later.