Gasboy ATC M05819K00X Kits User Manual
Page 17
MDE-4431C Gasboy ATC M05819K00X Kits Installation Manual · February 2013
Page 17
Installing the Commercial Atlas (9800K) ATC Kits
29
In the Polycase Box (LP-70), locate the DIP Switches shown in
and set
the switches for the proper unit as shown in the following table.
DIP Switch Settings
Switch
Number
Switch
Function
Settings for Existing and Model
9850K
Settings for Models
9840K, 9852K, 9853K
1
Product 1
ON for Diesel, OFF for Gasoline
ON for Diesel, OFF for Gasoline
2
Product 2
ON for Diesel, OFF for Gasoline
ON for Diesel, OFF for Gasoline
3
Not used
N/A
N/A
4
Unit of Measure N/A
ON for Liters, OFF for Gallons
5
Pulser Multiplier ON for 9850 and 9850K, OFF for
9852/9853
N/A
6
Number of
Probes
ON for two (2) probes, OFF for one (1)
probe
ON for two (2) probes, OFF for one (1)
probe
7
Pulser Adder
ON for 9840
ON for 9840K
8
ATC
ON for ATC ON, OFF for ATC OFF
ON for ATC ON, OFF for ATC OFF
30
Remount the Polycase Box (LP-70) cover removed in step
on
.
31
Using two of the crimp splices, connect the two yellow wires extending from the bottom of the
IS Barrier Mounting Stud to the two blue wires attached to the Single Probe Connector
Assembly.
32
Cap the end of the two green wires extending from the bottom of the IS barrier, using two
Caps (0M0205) or suitable size wire nuts (these are not part of the kit).
33
Locate the following parts provided in the kit (for parts identification, see
):
• Probe Assembly (W199)
• Thermowell (BC407)
• Thermowell Plug (235-C)
• Adapter (BC546)