beautypg.com

Firmware bootloading – DC Power Technologies Charger Interface Software Manual User Manual

Page 32

background image

31

© 2014 Enatel Motive Power Ltd. Specifications subject to change without prior notice. Errors

exempt. Pictures may be representative, actual products may differ.

5. Firmware Bootloading

Updated

firmware

(embedded

software) for either charger or
battery module may be made
available to address issues or add
features. New firmware is loaded
from PC to the device in a process
called bootloading.

Bootloading

requires

Advanced

Access.

Irreversible damage to the charger
controller may occur if the bootload
process

is

interrupted

once

underway. Bootloading should be
performed with a reliable AC supply

for both PC and charger. Ensure
any automatic sleep or shutdown
settings

are

disabled

during

bootloading.

Bootloading a Battery Module

Bootloading a battery module
requires that the associated battery
is connected to the charger. In this
way the charger acts as a host to
communicate with the battery
module. Otherwise the process to
bootload a module is the same as
for that of a charger, as below.

Bootload Process – Charger or Battery Module

1. Connect to the charger USB

port

and

confirm

PC

communication

with

the

charger

has

been

established.

Open

the

Bootloader tab.

2. Click Read Controller or

Read Battery Module to
confirm the current target
serial number and firmware
version.

3. Click Open File to select the

supplied HEX firmware file
from the PC.

4. The software reads the

selected firmware file and
determines the appropriate
target – charger or battery

module.

5. Click Program to begin the

bootloading process. Do not
interrupt the power supply or
connectivity to the charger,
battery module or PC during
this operation.

6. The display window will

indicate

a

single

line

“SUCCESS”

once

the

bootload is complete”.

If bootloading a charger,

the bootload should be
checked by cycling the AC
supply

and

confirming

operation of the front
panel display.

Additional Options

Reset Profiles

This option clears any profiles in
the charger to the factory profiles
included with the firmware.

Load Settings From File

As a part of the bootload process,
the

charger

settings

are

automatically saved to the PC, and

loaded back to the charger before
displaying “SUCCESS”. This option
allows manual selection of the
settings file.

Save Settings To File

Charger settings can be manually
saved to file for backup purposes.