DC Power Technologies Charger Interface Software Manual - Manual (Page 21)

20
© 2014 Enatel Motive Power Ltd. Specifications subject to change without prior notice. Errors
exempt. Pictures may be representative, actual products may differ.
Specify minimum voltage limit during
desulphation charge.
Desulphation Maximum Voltage
Specify maximum voltage limit during
desulphation charge.
Network Identifier
Optional unique identifier for large
networked charger installations.
Keypad Beep
Enable or disable audible feedback on
front panel buttons.
Backlight Brightness
Set minimum and maximum values for
LCD backlight. Default Min:0, Default
Max: 255
Display Contrast
Adjust readability of LCD. Default: 350
Charger Serial Number
Read or change the serial number of
the charger.
Service Mode
Allows manual specification of charge
parameters. Charger operation is
possible at a defined voltage, current
and duration.
CAUTION: Normal charger self-
protection features are disabled in this
mode.
Refresh All
Read all visible values from the
charger.
2.16. Battery Module Monitoring Tab
View real-time and accumulated data from a connected battery module.
Availability of battery current data depends on the model of battery module.
Status
Critical, real-time battery data.
Active Alarms
Alarms reported by the module as
currently active.
Counters
Battery charge, discharge and other
battery condition data as accumulated
by the battery module.
 Right-click on the Counters
section to adjust the reporting
parameters.