Single and dual profile charging – DC Power Technologies Charger Interface Software Manual User Manual
Page 26

25
© 2014 Enatel Motive Power Ltd. Specifications subject to change without prior notice. Errors
exempt. Pictures may be representative, actual products may differ.
Single and Dual Profile Charging
3.2.1.
A charger may be connected to a battery module that is configured for either
a Single or Dual Profile operation. The charger behaviour depends on both
the module and charger configurations.
The charger must be APC Enabled to one of two types:
APC Enabled (Single Profile)
A charger set to APC Enabled (Single
Profile) and connected to a battery
module will perform a single profile
charge.
Single Profile module:
Charges using the module’s single
Primary Profile
Dual Profile module:
Charges using the module’s Secondary
Profile, ignoring the Primary Profile.
APC Enabled (Dual Profile Capable)
A charger set to APC Enabled (Dual
Profile Capable) and connected to a
battery module will perform as follows.
Single Profile module:
Charges using the module’s single
Primary Profile
Dual Profile module:
Charges first using the Primary Profile
followed by the Secondary Profile. The
Primary Profile must be correctly
configured to engage the secondary
profile.
Single and Dual Profile Operation Summary
The table below shows the various configurations of module and charger
configuration and the resulting profile that is used.
* The Primary Profile in this case must be correctly configured to initiate the
Secondary Profile.
Module Configuration
Single Profile
Dual Profile
C
h
ar
g
er
APC
C
o
n
fi
g
u
rat
io
n
Single Profile
Primary Profile Only
Secondary Profile Only
Dual Profile
Capable
Primary Profile Only
Primary Profile
Then
Secondary Profile*