beautypg.com

Larm, Onfiguration, Alarm configuration tab – DC Power Technologies Charger Interface Software Manual User Manual

Page 19

background image

18

© 2014 Enatel Motive Power Ltd. Specifications subject to change without prior notice. Errors

exempt. Pictures may be representative, actual products may differ.

2.13. Alarm Configuration Tab

Requires Advanced Access.

The various charger alarms are, by
default, organised into Urgent and
Non-Urgent levels. The level of
the alarm determines the charger’s
response to that alarm. In addition
to alarm levels, alarms can also be
configured to activate one of two
relays, or activate the in-charger
audible beep.

Read/Write

Click Read to view each of the lists
stored in the charger, Write to
save any changes to a list back to
the charger.

Lists

Six lists allow addition and removal
of alarms from each category as
labelled at the top of each list.

Right-clicking in a list allows a new
alarm to be added to that list.

Right-clicking on a selected alarm
in a list allows the option to remove
that alarm from the list.

Refer to Section 6: Alarms for a list
of the default alarm lists.

Alarm Configuration Lists:

Alarm Log

Alarms listed here will appear in
the alarm log.

Urgent Alarm

Alarms categorized as Urgent
terminate the charge cycle and
alarm and charge logs are flagged
with the event. Notification is by a
front panel display message and
alternate

flashing

Ready

and

Charging LEDs.

Non-Urgent Alarm

Alarms categorized as Non-Urgent
allow the charge cycle to continue.
Flags alarm log. Notification is by
front panel display and flashing red
Charging LED.

Alarm Relays 1 & 2

Alarms selected to activate an on-
board

relay

for

external

accessories.

Buzzer

Alarms selected to produce an
audible tone from the charger when
triggered, until the alarm condition
is cleared or the charge cycle is
complete.