Comtech EF Data TRP500 - Manual (Page 96)

TRP500-4450 C-Band Outdoor Amplifier REVISION 1
Appendix B MN-TRP500
B–30
Parameter Type Command
(Instruction
Code and
Qualifier) Arguments for
Command or
Response to
Query Description of Arguments
(Note that all arguments are ASCII numeric
codes between 48 and 57) Response to
Command
(Target to Controller) Query
(Instruction
Code and
Qualifier) Response to
Query
(Target to
Controller)
Retrieve Utility
Status N/A 23 bytes,
alpha- numeric
Query only.
Used to Query the utility status of the unit.
Example: <1/RUS=’cr’
>0001/RUS=’cr’
ADR=0001’cr’
BDR=09600’cr’’lf’
Where:
ADR = Remote Unit Address
BDR = Remote Baud Rate
RUS= RUS? RUS=x….x
(See description
for details of
arguments)
Serial Baud Rate SBR= 4 bytes Command or Query.
Set serial baud rate as follows:
2400 = 2400 baud
4800 = 4800 baud
9600 = 9600 baud
19K2 = 19200 baud
38K4 = 38400 baud
Examples: <1/SBR=9600’cr’
>0001/SBR=9600’cr’’lf’
<1/SBR?’cr’
>0001/SBR=09600’cr’’lf’
Note: When changing baud rates remotely the
response to the command will be returned using the
same baud rate as that used to send the command.
Default Value: 9600
SBR=
SBR?
SBR* SBR?
SBR=xxxxx
(Same format as
command
arguments)
Summary Fault
Status
E
N/A 1 byte Query only.
Indicates the condition of the summary fault relay.
Where:
0 = Not Faulted (SumFLT_COM J6 pin K is not
connected to SumFLT_NC J6 pin M)
1 = Faulted (SumFLT_COM J6 pin K is connected to
SumFLT_NC J6 pin M)
Example: <1/SFS?
>0001/SFS=0’cr’’lf’
SFS= SFS? SFS=x
(See description
for details of
arguments)