Comtech EF Data TRP500 - Manual (Page 74)

TRP500-4450 C-Band Outdoor Amplifier REVISION 1
Appendix B MN-TRP500
B–8
B.3 Remote Commands and Queries
Column ‘C’ = Command; Column ‘Q’ = Query; columns marked ‘X’ designate instruction code as Command only, Query only, or Command/Query.
• Where an Instruction Code is noted XXX E this denotes a command/query designated as EOL. See Sect. 3.2 for more information.
• Where an Instruction Code is noted XXX O this denotes a command/query that is available only when a reference oscillator is installed.
CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE Note: The following codes are used in the
‘Response to Command’ column:
A G P T
AFR X X B-9 GAC X X B-16 PNM X B-23 TIM X X B-31 CODE MEANING
AMP X X B-9 TMP X B-31 = Message OK
AUX X X B-10 I R TNA E X B-32
?
Received OK, but invalid arguments
found
IEP X B-17 RAS X B-24 TSC X B-32
C IMG X X B-17 RBT X B-24
*
Message OK, but not permitted in
Current mode
CAA E X B-10 IPA X X B-17 RCS X B-25
CAE X B-10 IPG X X B-18 RED X X B-25
#
Message OK, but only permitted in
Remote mode
CAS X B-11 ISP X B-18 RET E X B-25
CCS X B-12 RFS X B-26 ! Unknown command
CFS X B-12 L RMS X B-27
CID X X B-12 LNA E X B-19 RNE X B-28
CMS X B-13 LPT X X B-19 RNS X B-29
CSL X B-13 LRS X X B-20 RPT X B-29
CUS E X B-14 RSN E X B-29
M RUS X B-30
D MAC X B-20
DAT E X X B-14 MSK X X B-21 S
DAY X X B-14 MUT X X B-22 SBR X X B-30
SFS E X B-30
E N SNO X X B-31
ESA X X B-14 NUE X B-22 SPA X X B-31
ESL X X B-15 NUS X B-22 SSI X X B-31
ESW X X B-15
O
F OFM X X B-23
FRW X B-15 ONL X X B-23