Comtech EF Data TRP500 - Manual (Page 42)

TRP500-4450 C-band Outdoor Amplifier Revision 1
Ethernet Management MN-TRP500
4–6
4.5 Web Server (HTTP) Interface
The sections that follow describe the functionality of the TRP500 Web Server (HTTP)
Interface. Please refer to the REMOTE CONTROL Specifications tables found in Appendix B.
REMOTE CONTROL for detailed descriptions of the configuration parameters featured on
the individual Web pages shown in this chapter.
4.5.1 Web Server Page Introduction
The embedded Web Server application provides the user with an easy to use interface to
configure and monitor all aspects of the TRP500. These Web pages have been designed for
optimal performance when using Microsoft’s Internet Explorer Version 5.5 or higher (the
examples shown use Internet Explorer Version 6.0).
The user can fully control and monitor base operations of
the TRP500 from the Web Server Interface. By rolling the
cursor over the navigation tabs located at the top of each
page (right), the user can select from the available nested
hyperlinks.
4.5.2 Enabling the Web Server Interface
To enable the Web Server Interface in the TRP500 using only a 100BaseTx remote interface (this
assumes the user is running an Microsoft Windows OS):
1. Select Start, then Run,
then type “cmd” to open
the command prompt
window:
2. Start a Telnet session with
the unit at the default IP
address of 192.168.1.4: