Comtech EF Data TRP500 - Manual (Page 81)

TRP500-4450 C-Band Outdoor Amplifier REVISION 1
Appendix B MN-TRP500
B–15
Parameter Type Command
(Instruction
Code and
Qualifier) Arguments for
Command or
Response to
Query Description of Arguments
(Note that all arguments are ASCII numeric
codes between 48 and 57) Response to
Command
(Target to Controller) Query
(Instruction
Code and
Qualifier) Response to
Query
(Target to
Controller)
Enable Statistics
Logging ESL= 1 byte Command or Query.
Enables or Disables the statistics logging function.
0 = Disable
1 = Enable
Example: <1/ESL=1’cr’
>0001/ESL=’cr’’lf’
Default Value: 0
ESL=
ESL?
ESL* ESL? ESL=x
(Same format as
command
arguments)
Enable
Redundancy
Switch Mode ESW= 1 byte Command or Query.
Turns ON or OFF the redundancy state, where:
0 = Off
1 = 1:1 Redundancy TX (Only TX switch installed)
2 = 1:1 Redundancy TX + RX (TX and RX switch
installed)
5 = 1:1 Manual redundancy mode (used for
debugging, or redundant system setup). Manual
redundancy does not support automatic switching,
and the offline unit will not poll the online unit to
update its configuration.
Example: <1/ESW=1’cr’
>0001/ESW=’cr’’lf’
Default Value: 0
ESW=
ESW?
ESW * ESW? ESW=x