Comtech EF Data TRP500 - Manual (Page 91)

TRP500-4450 C-Band Outdoor Amplifier REVISION 1
Appendix B MN-TRP500
B–25
Parameter Type Command
(Instruction
Code and
Qualifier) Arguments for
Command or
Response to
Query Description of Arguments
(Note that all arguments are ASCII numeric
codes between 48 and 57) Response to
Command
(Target to Controller) Query
(Instruction
Code and
Qualifier) Response to
Query
(Target to
Controller)
Retrieve
Configuration
Status N/A 45 bytes Query only.
Used to Query the configuration status of the unit
Example:
RCS=’cr’
AMP=1’cr’
MUT=1’cr’
ONL=1’cr’
ESW=1’cr’
AFR=1’cr’’lf’
Where:
AMP= RF power amplifier state, 0=OFF, 1=ON
MUT=RF mute state, 0=un-muted, 1=muted
RED=Online status for redundancy
ESW=Redundancy state and mode,
states: 0=OFF, 1=ON Tx only, 2=ON Tx & Rx
AFR= auto fault recovery, 0=manual, 1=auto
RCS= RCS? RCS=x….x
(See description
for details of
arguments)
Online Status RED= 1 byte Command or Query.
Online status (applies only to redundancy), where:
0 = Offline
1 = Online
Note: this command is functionally identical to the
ONL command.
Example: <1/RED=1’cr’
>0001/RED=’cr’’lf’
RED=
RED?
RED* RED? RED=x
Retrieve
Equipment Type N/A 22 bytes Query only.
The unit returns a string indicating the Model Number
and the version of the M&C firmware installed in the
unit.
Example: <1/RET?’cr’
>0001/RET=CPA-300 VER: 1.0.3’cr’’lf’
RET= RET? RET=x….x
(See description
for details of
arguments)