Comtech EF Data TRP500 - Manual (Page 84)

TRP500-4450 C-Band Outdoor Amplifier REVISION 1
Appendix B MN-TRP500
B–18
Parameter Type Command
(Instruction
Code and
Qualifier) Arguments for
Command or
Response to
Query Description of Arguments
(Note that all arguments are ASCII numeric
codes between 48 and 57) Response to
Command
(Target to Controller) Query
(Instruction
Code and
Qualifier) Response to
Query
(Target to
Controller)
Gateway Address IPG= 15 bytes Command or Query.
Used to set the Gateway IP address for the 10/100
Base Tx Ethernet management port, in the format:
xxx.xxx.xxx.xxx, where:
xxx.xxx.xxx.xxx is the IP address
Example: <1/IPG=192.168.001.005’cr’
>0001/IPG=’cr’’lf’
Default Value: 192.168.001.005
IPG=
IPG?
IPG* IPG? IPG =
xxx.xxx.xxx.xxx
Initialize Statistics
Pointer ISP= None Command only.
Resets internal pointer to allow RNS? Queries to start
at the beginning of the stored statistics log.
Example: <1/ISP=’cr’
>0001/ISP=’cr’’lf’
ISP=
ISP?
ISP* N/A N/A