Comtech EF Data TRP500 - Manual (Page 53)

TRP500-4450 C-band Outdoor Amplifier Revision 1
Ethernet Management MN-TRP500
4–17
4.5.5.3.2 Config | Utility
Figure 4-7. Config | Utility page
The ‘Config | Utility’ page (Figure 4-7) is used to configure TRP500 operating parameters.
Date and Time
• The user may enter a date using international format in the form DD/MM/YY (where
DD = day [01 to 31], MM = month [01 to 12], and YY = year [00 to 99]).
• The user may enter a time using HH:MM:SS format (where HH = hour [00 to 23],
MM = minutes [00 to 59], and SS = seconds [00 to 59]).
Once the desired date and time have been entered in this section, the user should then click
[Change Date/Time] as needed to save these changes.
Circuit ID
The user may enter a Circuit ID string of up to 48 characters. Once the desired string had been
entered in this section, the user should then click [Enter Circuit ID] as needed to save this change.
Current Active Firmware Image (read-only)
Identifies the selected Current Active Firmware Image. In this example, Image 2 is the
Current Active Firmware Image.