Comtech EF Data MD2401 - Manual (Page 19)

MN-MD2401 2–1
Revision 7
Chapter 2. Installation
2.1 Unpacking and Inspection
Inspect shipping containers for damage. If shipping containers are damaged, keep them until the
contents of the shipment have been carefully inspected and checked for normal operation.
The MD2401Multi-Demod Reciever and its Installation and Operation Manual are packaged and
shipped in a pre-formed, reusable cardboard carton containing foam spacing for maximum shipping
protection.
CAUTION
Do not use any cutting tool that will extend more than 1/2 inch into the
container. This can cause damage to the modem.
Unpack and inspect the modem as follows:
Step Procedure
1 Cut the tape at the top of the carton indicated by OPEN THIS END .
2 Remove the cardboard/foam space covering the modem.
3 Remove the modem, power cord, and user’s manual from the carton.
4 Save the packing material for storage or reshipment purposes.
5 Inspect the equipment for any possible damage incurred during shipment.
Note: If damage is evident, contact the carrier and Comtech EF Data immediately
and submit a damage report.
6 Check the contents against the packing list to verify completeness of the
shipment.
7 Refer to the sections that follow for further installation instructions.
The MD2401 Modulator was carefully packaged to avoid damage and should arrive complete with
the following items for proper installation:
1.
MD2401 Multi Demod
2. Power Cord, six foot with applicable AC Connector
3. Installation and Operation Manual