Cautions and warnings, Recommended standard designations, Electrical safety – Comtech EF Data MD2401 User Manual
Page 10: Battery, Grounding

MD2401 L-Band Multi Demod Installation and Operation Manual
Revision 7
Preface
MN-MD2401
xx
Cautions and Warnings
WARNING
WARNING indicates a potentially hazardous situation that, if not avoided,
could result in death or serious injury.
CAUTION
CAUTION indicates a hazardous situation that, if not avoided, may result in
minor or moderate injury. CAUTION may also be used to indicate other unsafe
practices or risks of property damage.
IMPORTANT
IMPORTANT or NOTE indicates information critical for proper equipment
function.
Recommended Standard Designations
Recommended Standard (RS) Designations have been superseded by the new designation of the
Electronic Industries Association (EIA). References to the old designations are shown only when
depicting actual text displayed on the screen of the unit (RS-232, RS-485, etc.). All other references
in the manual will be shown with the EIA designations.
IMPORTANT
The user should carefully review the following information.
Electrical Safety
The MD2401 has been shown to comply with the EN 60950-1 Safety of Information
Technology Equipment (including electrical business machines) safety standard.
The equipment is rated for a nominal operating range of 100 - 240 volts AC. The unit has a
maximum power consumption of 250 watts.
Battery
The modem contains a Lithium Battery.
DANGER OF EXPLOSION EXISTS
if the
battery is incorrectly replaced. Replace only with the same or equivalent type
recommended by the manufacturer. Dispose of used batteries in accordance
with local and national regulations.
Grounding
PROPER GROUNDING PROTECTION REQUIRED: The installation instructions
require that the integrity of the protective earth must be ensured and that the
equipment shall be connected to the protective earth connection at all times.
Therefore, it is imperative during installation, configuration, and operation that
the user ensures that the unit has been properly grounded using the ground
stud provided on the rear panel of the unit.