BayTech MRP units 2012 - Manual (Page 44)

Page
44
Network Port Configuration
Menu 7: Network Port Configuration
IP Address
Subnet Mask
The Subnet Mask is a bit mask that identifies the network portion of the IP address, allowing the RPC to
determine whether to send a packet directly to the client or to a gateway. The Subnet Mask consists of
four bytes, each byte ranging from 0 to 255. This parameter must be programmed before the MRP
can be accessed through the network.
The IP address is the network address assigned by your network manager for your network. The IP
Address consists of four bytes, each byte ranging from 0 to 255. This parameter must be programmed
before the MRP can be accessible via the network.
NOTE: There should be no active connections while configuring the MRP. The unit should be
reset upon completion of configuration.
Select 8), from the Network Configuration
Menu, this menu is used to change the
network configuration options such as the IP
Address, Subnet Mask, Gateway, DHCP,
and Telnet; all of which are necessary during
initial startup. The Connection Inactivity
Timeout allows you to enable/disable
whether the firmware will end your session
or “times out.” The default is 1 hour, but
when disabled there is no set time out.
Disabling the Carriage Return Translation
allows you to bypass all unnecessary
carriage returns, and it will send you straight
to the next “end of line.” The DHCP,
Telnet, SSH, options is to enable or disable
these functions. SSH host key Generator
allows the user to generate a host key which
is used in the SSH encryption process. IP
Filter allows or blocks specific IP
Addresses,
SNMP provides a message format for communication between a computer and your devices,
and Web Server Configuration allows web access and sets up options for each.
Network setup :
Ethernet Address................ 00:C0:48:00:01:FD
IP Address...................... 70.150.140.89
Subnet Mask..................... 255.255.255.224
Default Gateway................. 70.150.140.65
Connection Inactivity Timeout (mins): Disabled
Carriage Return Translation: Enabled
Break Length (msecs): 350
DHCP is Disabled Telnet is Enabled SSH is Enabled
SSH host keys are set to factory default
IP Address........................1
Subnet Mask.......................2
Gateway Address...................3
Inactivity Timeout................4
Carriage Return Translation.......5
Break Length......................6
DHCP Enable/Disable...............7
Telnet Enable/Disable.............8
SSH Enable/Disable................9
SSH Host Key Generation...........10
IP Filter Configuration...........11
SNMP Configuration................12
Web Server Configuration..........13
Exit..............................X,CR
Enter Request :
IMPORTANT: For network access, you must configure the IP addresses, Subnet Mask, and
Gateway Address. A unit reset must be performed for network changes to take effect.
Select 1), enters the IP Address. Failure to enter the address in the decimal form causes the unit to
display the following until it is entered correctly.
Default Module IP Address is 0.0.0.0.
Enter IP address in dotted decimal form :
Select 2), enters the Subnet Mask followed by . Failure to enter the address in the decimal form
causes the unit to display the following until it is
entered correctly. Default Subnet Mask is 0.0.0.0.
Enter Subnet Mask in dotted decimal form :