BayTech MRP units 2012 - Manual (Page 33)

Page
33
Current Routing Cache
Route Setup
Processes
UnitInfo Database
Kernel IP routing cache
Source
Destination Gateway Flags Metric Ref Use Iface
66.186.36.195 70.150.140.86 70.150.140.86 l 0 0 1 lo
70.150.140.86 66.186.36.195 70.150.140.65 0 0 0 eth0
70.150.140.69 70.150.140.86 70.150.140.86 il 0 0 154 lo
207.206.133.250 70.150.140.86 70.150.140.86 l 0 0 76 lo
Press ENTER to continue
Select 5), displays the IP Data
currently held in cache or none
upon power cycle.
Select 6), Every TCP/IP client machine, regardless of operating system, needs to make decisions about
where to send a packet after it has been addressed. The route table is the network map that tells your
Baytech product how to deliver the packet to its network addressee.
 Destination is a list of routes. “0” represents any number.
 Gateway is the network gateway for the route. The connection point to your company network.
 Genmask defines how closely an address must match the network destination, octet by octet, to
use the route.
 Iface interface used to reach the network gateway, in this case Baytech network card.
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.2.0 * 255.255.255.0 U 0 0 0 eth0
127.0.0.0 * 255.0.0.0 U 0 0 0 lo
default 192.168.2.1 0.0.0.0 UG 0 0 0 eth0
Press ENTER to continue
Select 7), displays a list of Process
commands used by the firmware to operate.
Type “T”, and the unit will prompt for a PID number to terminate:
PID PORT STAT SIZE SHARED %CPU COMMAND
1 S 133K 0K 0.2 init
2 S 0K 0K 0.0 keventd
6 S 0K 0K 0.0 kupdated
11 R 43K 0K 99.3 baytechd
12 S 13K 0K 0.1 mdmautologind
13 S0 S 13K 0K 0.1 /bin/autologind
14 S 14K 0K 0.0 /bin/inetd
17 S 133K 0K 0.1 rpccmdd
18 S 13K 0K 0.0 snmppolld
19 S 1833K 0K 0.0 snmpd
25 S0 R 71K 0K 1.0 ds62
Strike T, CR to terminate a connection/process,
CR to continue :
Enter PID process to terminate, CR:
IMPORTANT: If a process is
terminated, the functionality of the unit
unitInfo->portUser 0
unitInfo->cfgUser 0
unitInfo->connState 0
unitInfo->connPid 0
unitInfo->buildUserTableFlag 0
unitInfo->kill_poller 0
unitInfo->background_polling=0
bcTable->connAttempt=0
maybe interrupted. To reestablish the
unit’s functionality, power the unit off
than on.