BayTech MRP units 2012 - Manual (Page 21)

Page
21
Detail Operations and Configurations
NETWORK MENU
Single Unit Menu
CASCADE ENABLED Menu
NOTE: Option (2) and option (O) are for units set
for Cascade operations.
Module: 1
Attention Character: ;
MRP27 (2 ,1).........1
Status..........................S
Configure.......................C
Unit Reset......................RU
Logout..........................T
Enter Request :
Universal RPC login: root
Password:
BAYTECH
For further information check:
http://www.baytech.net/
opening access to internal RPC
MRP-27 Series
(C) 2008 BayTech
F1.11
Option(s) Installed:
True RMS Voltage
True RMS Current
Internal Temperature
Enter user name:
After logging into the unit, the unit will display
additional hardware information:
Outlet controller firmware, F1.11
Options installed Voltage and Current sensors and
Internal Temperature Sensor.
(Opening access to internal RPC) signifies the
processor is checking to see what is installed.
“Enter user name:” will appear if a user has been
assigned to the Outlet Controller
Module: 1
Attention Character:
MRP27 (2 ,1).........1
MRP27 (2 ,2).........2
Outlet Group Control............O
Status..........................S
Configure.......................C
Unit Reset......................RU
Logout..........................T
Enter Request :s
The Network menu can be accessed through the
Ethernet or Console (EIA232) port.
1), opens the Outlet Controller Menu, Ethernet unit.
2), opens the Outlet Controller Menu, Non-Ethernet
unit.
O), opens the Cascade Outlet Controller Menu.
S), opens the Ethernet data Status.
C), opens the Network Configuration Menu.
RU), opens the reset decision.
T), close session