BayTech MRP units 2012 - Manual (Page 17)

Page
17
Figure 3: Outlet Password
Figure 4: Outlet Configuration
Manage User
Figure 5: Outlet Manage User
Add a User:
MRP>password
Enter new Password: *****
Re-Enter new Password: *****
Type Help for a list of commands
MRP>
MRP>config
Unit ID: MRP20
1)...Manage
Users Add/Delete/Rename, assign outlets
2)...Change Outlet Name Select an outlet to change its name
3)...Enable/Disable Confirmation Confirmation (Y/N)
4)...Enable/Disable Status Menu Opening status of outlets
5)...Change Unit ID As written
6)...Change Alarm Threshold As written
7)...Change Display Orientation Flip Display
X)...Exit
NOTE: If the unit display with the following message, “Configuration mode in use”
A user in the other port is in the “Configuration” menu.
Power Controller Configuration Menu: To select the configuration menu, type ‘config’ at
the prompt.
The User Menu allows the admin user to add and delete users, change passwords, and change the outlet
list that displays a user’s access to prescribed outlets. Select “Manage Users,” from the configuration
menu and the following menu appears if the unit has been reset or initial setup:
-------------------------------------------
| User | Assigned Outlets |
| | C1,1| C1,2| C1,3| C1,4|
-------------------------------------------
-------------------------------------------
A)...Add User
D)...Delete User
R)...Rename User
C)...Change Circuit Group
Enter user number to assign Outlets, A, D, C or R.
Enter Request:
NOTE: User in position (1) will be the ‘admin user’ for the outlets. Older units will not display
the ‘delete’ option until a user is added.
Select A), “Add user,” from the User Management Menu.
Enter the name of the user to be added, followed by .
NOTE: User name is
case sensitive.
Password setting: Once you have logged out and log back in as a user or as the
administrator, you can then set the password to gain access. Type “Password”