Baby Lock Destiny (BLDY) Instruction & Reference Guide-Part2 - Manual (Page 56)

CONFIRMING THE PATTERN POSITION
249
Bas
ic Em
b
ro
ide
ry
5
The pattern is normally positioned in the center of the embroidery frame. If the pattern needs to be
repositioned for better placement on the garment, you can check the layout before starting embroidery.
Checking the Needle Drop Point
With the Embroidery Foot “W+”
with LED Pointer
With the embroidery foot “W+” with LED pointer,
you can check the needle drop position before
embroidering.
a
Press in the embroidery screen.
→ The LED pointer indicates the needle drop point.
* The LED pointer turns off automatically by lowering
the presser foot or returning to the previous page.
■ Adjusting the LED Pointer
Adjust the LED pointer if it indicates a point different
than the actual needle drop point. Before adjusting
the LED pointer, mark the actual needle drop point
on the fabric to be embroidered, and then hoop the
fabric and attach the embroidery frame.
a
Press .
→ The settings screen appears.
b
Display page 8 of the Embroidery settings
screen.
c
Press .
→ The Embroidery Foot “W+” with LED Pointer
Adjustment screen appears.
a LED pointer adjustment
CONFIRMING THE PATTERN POSITION
Memo
• When the LED pointer is turned on, the
presser foot height is automatically adjusted
according to the fabric thickness.
• If is not displayed, you cannot use the
LED pointer.
Note
• With bulky fabrics, the position may not be
accurate due to the various depths of the
fabrics.
• With fabric that has a very uneven surface
such as quilting, the fabric thickness may
not be correctly measured. In this case, the
pointer indication should be used only as a
reference.
Note
• As a default, the key mentioned in the
following procedures appear in light gray
and is not available. To enable the key for
specifying the settings, attach embroidery
foot “W+” with LED pointer to the machine.
The key is enabled after the embroidery foot
is plugged in.
a