Baby Lock Destiny (BLDY) Instruction & Reference Guide-Part2 - Manual (Page 184)

CARE AND MAINTENANCE
377
A
ppe
ndi
x
9
f
Grasp the bobbin case, and then gently lift
out.
a Bobbin case
g
Use the cleaning brush or a vacuum cleaner
to remove any lint and dust from the race
and bobbin thread sensor and the
surrounding area.
a Cleaning brush
b Race
c Bobbin thread sensor
h
Insert the bobbin case so that the S mark
on the bobbin case aligns with the
●
mark
on the machine.
* Align the S and
●
marks.
a S mark on the bobbin case
b
●
mark on the machine
c Bobbin case
*
Make sure that the indicated points are aligned
before installing the bobbin case.
i
Insert the tabs on the needle plate cover
into the needle plate, and then slide the
cover back on.
Note
• Do not apply oil to the bobbin case.
• If lint or dust collects on the bobbin thread
sensor, the sensor may not operate
correctly.
a
b
CAUTION
• Never use a bobbin case that is scratched;
otherwise, the upper thread may become
tangled, the needle may break, or sewing
performance may suffer. For a new bobbin
case (part code: XE5342-101 (green marking
on the screw), XC8167-551 (no color on the
screw), XE8298-001 (gray, for bobbin work)),
contact your nearest authorized retailer.
• Make sure that you fit the bobbin case
properly, otherwise the needle may break.
Note
• If the needle plate has been removed it is
especially important to reinstall the needle
plate and tighten the screws prior to
installing the bobbin case.
b a