Baby Lock Destiny (BLDY) Instruction & Reference Guide-Part2 - Manual (Page 4)

BEFORE EMBROIDERING
197
Bas
ic Em
b
ro
ide
ry
5
Attaching Embroidery Foot “W+”
with LED pointer
a
Remove the presser foot and presser foot
holder. For details, refer to “CHANGING
THE PRESSER FOOT” on page 68.
b
Position the embroidery foot “W+” with
LED pointer on the presser foot bar by
aligning the notch of the presser foot to the
large screw.
Side view
c
Hold the embroidery foot in place with
your right hand, and then use the included
multi-purpose screwdriver to securely
tighten the presser foot holder screw.
a Presser foot holder screw
d
Plug the connector of the embroidery foot
“W+” with LED pointer into the jack on the
back left side of your machine.
e
Press to unlock all keys and buttons.
→ All keys and operation buttons are unlocked, and
the previous screen is displayed.
Attaching the Embroidery Unit
■ About the Embroidery Unit
CAUTION
• When attaching a presser foot, always press
on the screen. You may accidentally
press the “Start/Stop” button and possibly
cause injury.
• Be sure to use embroidery foot “W+” with LED
pointer or “W” (optional) when doing
embroidery. Using another presser foot may
cause the needle to strike the presser foot,
causing the needle to bend or break and
possibly cause injury.
CAUTION
• Use the included multi-purpose screwdriver to
firmly tighten the screw of the presser foot
holder. If the screw is loose, the needle may
strike the presser foot and possibly cause
injury.
CAUTION
• Do not move the machine with the embroidery
unit attached. The embroidery unit could fall
off and cause injury.
• Keep your hands and foreign objects away
from the embroidery carriage and frame when
the machine is embroidering. Otherwise,
injury may result.
• To avoid distorting your embroidery design, do
not touch the embroidery carriage and frame
when the machine is embroidering.