Baby Lock Destiny (BLDY) Instruction & Reference Guide-Part2 - Manual (Page 178)

CREATING BOBBIN WORK (EMBROIDERY)
371
H
o
w
to
Cr
ea
te
Bob
b
in
W
o
rk
8
properly secured.
n
Using a hand sewing needle such as a
ribbon embroidery needle, pull the bobbin
thread to the top (wrong side) of the fabric,
and then tie the upper thread and the
bobbin thread together.
o
Remove the fabric from the embroidery
frame, and check the finished embroidery.
p
If the desired results could not be achieved,
adjust the tension of the bobbin thread and
of the upper thread, and then try sewing the
pattern again.
For more details, refer to “ADJUSTING BOBBIN
WORK THREAD TENSION” on page 372.
Memo
• If there is a gap between the start point and
end point of the pattern, cut the threads,
remove the fabric from the machine, and
then use a ribbon embroidery needle to
hand sew stitches to connect the starting
and ending points.
a Right side of fabric b Wrong side of fabric
Memo
• Check bobbin after each bobbin work
embroidery pattern is sewn to make sure
there is adequate bobbin thread for the next
pattern.