Baby Lock Destiny (BLDY) Instruction & Reference Guide-Part2 - Manual (Page 171)

PREPARING FOR BOBBIN WORK
364
o
Gently pull the upper thread to bring the
bobbin thread up through the needle plate.
→ A loop of the bobbin thread comes out through the
hole in the needle plate.
p
Insert tweezers through bobbin thread loop
and pull bobbin thread above the needle
plate.
q
Align the upper thread and bobbin thread,
and then pull out about 10 cm (approx.
4 inches) of the threads and pass them
under the presser foot toward the rear of
the machine.
r
Install the bobbin cover with tabs.
a Bobbin cover
→ This completes the upper and lower threading.
CAUTION
• When creating bobbin work, use the bobbin
cover with tabs, otherwise the thread may
become tangled or the needle may break.