Baby Lock Destiny (BLDY) Instruction & Reference Guide-Part2 - Manual (Page 139)

STITCH SETTINGS SCREEN
332
Before creating the embroidery pattern, specify the stitch settings. Lines of the design are sewn with
zigzag stitches, running stitches, or triple stitches, and areas are sewn with fill stitches or stippling stitches.
Stitching of the areas were already selected in “Drawing Regions” on page 328, so specify values of
detailed settings.
If the design data is saved, the settings can be changed after a trial embroidering.
After finished specifying the settings, press to check the preview of the pattern.
■ Line sew stitch settings
Select the type of the line sew stitch from zigzag stitch ( ), running stitch ( ) or triple stitch ( ).
Zigzag stitch
Running stitch /Triple stitch
* Both includes an under sewing.
■ Fill stitch settings
STITCH SETTINGS SCREEN
Zigzag width Specifies the width of the satin stitches used to sew the lines of the design.
Density Specifies the density of the satin stitches used to sew the lines of the design.
Run Pitch Specifies the length of the straight stitch of the design.
Size Increases/reduces the size of the pattern.
Direction Specifies the sewing direction. Set to “Manual” when you have desired direction of fill stitch.
Density Specifies the stitch density of fill stitch.
Pull compensation
Specifies to correct the shrinkage of the pattern by slightly shortening or lengthening the
stitching. Change the setting after once you embroider the pattern and check the shrinkage.
Under sewing Select if you need or not need the under sewing stabilize fabric.