Avery Dennison PCL - Manual (Page 60)

58 •••• Connection Guide PAXAR PCL
obtained from your IT specialist. Avery Dennison cannot provide this information since
it is unique for your network.
You will need to connect a standard PC monitor and keyboard to the printer. To set up
the printer IP address, perform the following steps:
1. Turn on the printer. During the initialization, the message “Press F1 to Enter Setup”
will appear on the monitor. Press the F1 key on the keyboard. This message will only
appear for about one second. If you don’t press F1 key in time, simply turn off the
printer and try again.
2. A window will appear asking for a password. Enter IP, then press the Enter key.
3. A menu will appear with options to view or enter the IP, Gateway and Sub-Mask
addresses. To view the current IP address, enter IP, then press Enter. The current IP
address will be displayed. To set the IP address, type IP followed by the IP address,
then press Enter. For example, if your IP address is 198.68.1.1, you would enter
IP 198.68.1.1
4. Repeat step 3 for the Gateway and Sub-Mask addresses.
5. To exit, type EXIT followed by the Enter key. The printer will restart.
For more information, see Engineering Bulletin 06_019_Ethernet_Configuration.doc.