Avery Dennison PCL - Manual (Page 49)

PAXAR PCL Reference Guide •••• 47
Special Codes for Graphic Image information
~MH9 630
This command specifies the expansion multiple for the logo in the pull direction.
~MV9 630
This command specifies the expansion multiple for the logo in the web direction.
~MR9 630,6X6,SNAP
This command specifies how the field will be drawn on the tag. There are four possible
ways to place the field's image on the tag. The DIRECT option is the default and will
print the image directly, as it was created. However, when part of the image or the
entire image is coincident with any part of a previously printed image, the two field
images will be compared in those areas where they are coincident.
The DIRECT option is specified by a 0 in the command. The dot will remain on only
when it is on in the last mapped image for that same dot position.
The AND option is specified by a 1 in the command. The dot will remain on only
when it is on in both images for that same dot position.
The OR option is specified by a 2 in the command. The dot will remain on if the dot is
on in either or both images for that same dot position.
The XOR option is specified by a 3 in the command. The dot will remain on only
when it is on in one of the images - but will not be on if it is on in both images for
that same dot position.
The INVERSE option is specified by a 3 in the command. The dot will remain on only
when it is off in the last mapped image for that same dot position.
Compatibility Note:
630 These printers support DIRECT, AND, OR, and XOR.
636X6,SNAP These printers only supports DIRECT, OR, and INVERSE.
Special Codes for RFID Fields
~KS99 700RFID
This command activates auto-incrementing. Auto-incrementing means that this field
will start at the data value which it is sent and increment using the step size that is
specified in this command. The step size of the increment is specified in 99. An
increment of zero turns off auto-incrementing.
NOTE
The printer does not check the formatting of the EPC field. It is the user’s
responsibility to ensure that incrementing is limited to the serialized portion of
the EPC field. For example, if the last 4 characters of the EPC field are
reserved for serialization, batches greater than 9999 will overflow the serial
field.