Avery Dennison PCL - Manual (Page 44)

42 •••• Reference Guide PAXAR PCL
Special Codes for Care Symbol Information
~SH9 630
This command specifies the expansion multiple for the care symbol in the horizontal
direction.
~SV9 630
This command specifies the expansion multiple for the care symbol in the vertical
direction.
~ST99 630,960,6X6,SNAP
This command specifies the care symbol type.
Compatibility Note:
630 The care symbol images reside on the I.C. card which plugs into the side of the
630 printer. In order for a care symbol type to be chosen the care symbol type
must be present on the I.C. card and the I.C. card must plugged into the printer in
order for a format layout that contains a care symbol field to work. The standard
type for care symbols on the 630 is type 9. The 630 will default to type 9 when
the care symbol field is created. This command is only necessary if the care
symbols are stored as a non-standard type number.
960 On the 960, a symbol type of 1 is printed as large care symbols and a symbol type
of 2 is printed as small care symbols.
6X6,SNAP On these printers, a symbol type of 1 is printed as small care symbols and a
symbol type of 2 is printed as large care symbols.
~SR9 630,650,960,6X6,SNAP
This command specifies how the field will be drawn on the tag. There are four possible
ways to place the field's image on the tag. The DIRECT option is the default and will
print the image directly, as it was created. However, when part of the image or the
entire image is coincident with any part of a previously printed image, the two field
images will be compared in those areas where they are coincident.
The DIRECT option is specified by a 0 in the command. The dot will remain on only
when it is on in the last mapped image for that same dot position.
The AND option is specified by a 1 in the command. The dot will remain on only
when it is on in both images for that same dot position.
The OR option is specified by a 2 in the command. The dot will remain on if the dot is
on in either or both images for that same dot position.
The XOR option is specified by a 3 in the command. The dot will remain on only
when it is on in one of the images - but will not be on if it is on in both images for
that same dot position.
The INVERSE option is specified by a 3 in the command. The dot will remain on only
when it is off in the last mapped image for that same dot position.
Compatibility Note:
630, 960 These printers support DIRECT, AND, OR, and XOR.