Avery Dennison PCL - Manual (Page 43)

PAXAR PCL Reference Guide •••• 41
T The logo will be top justified.
C The logo will be centered vertically.
B The logo will be bottom justified.
~GR9 630, 650, 960, 636, 656, 676, 686, 545
This command specifies how the field will be graphically placed on the tag. There are
four possible ways to place the field's image on the tag. The DIRECT option is the
default and will print the image directly, as it was created. However, when part of the
image or the entire image is coincident with any part of a previously printed image, the
two field images will be compared in those areas where they are coincident.
The DIRECT option is specified by a 0 in the command. The dot will remain on only
when it is on in the last mapped image for that same dot position.
The AND option is specified by a 1 in the command. The dot will remain on only
when it is on in both images for that same dot position.
The OR option is specified by a 2 in the command. The dot will remain on if the dot is
on in either or both images for that same dot position.
The XOR option is specified by a 3 in the command. The dot will remain on only
when it is on in one of the images - but will not be on if it is on in both images for that
same dot position.
The INVERSE option is specified by a 3 in the command. The dot will remain on only
when it is off in the last mapped image for that same dot position.
Compatibility Note:
630, 960 These printers support DIRECT, AND, OR, and XOR.
650 The 650 only supports DIRECT, OR, and XOR.
636, 656, 676, 686, 545 These printers only supports DIRECT, OR, and INVERSE.
~GI99 630
This command specifies the intercharacter spacing of the selected logo. The value that
is included in this command is the number of dots that will be between the logos.
These dots are equivalent to 4 thousandths.