Avery Dennison PCL - Manual (Page 20)

18 •••• Reference Guide PAXAR PCL
~XO 6X6
This command tells the printer to print a mirror of the image. The image is mirrored on
the axis that is parallel to the printhead. Fields will be printed right to left with the
characters facing to the left as the fields go underneath the printhead.
~XD9999 PcMate Plus Display
This command refers to the dpi that was used to design the format. This is not a printer
command and can not be used to change the dpi of the printer. This command is used
for display purposes by the application that designs the formats for the printers.
240 - The format was designed for a 240-dpi printer.
300 - The format was designed for a 300-dpi printer.
~XX9999 PcMate Plus Display
This command refers to the specific printer the format was designed for. This is not a
printer command. This command is used for display purposes by the application that
designs the formats for the printers.
636, 656, 676, 686, 545, 500 (SNAP 500), 600 (SNAP 600),
700 (SNAP 700) - The printer the format was designed for.
~XE 6X6,SNAP
This command tells the printer to halt after every batch is printed regardless of how
many batches are in the printer. Without this command, the printer does not halt but
prints the batches continuously until there are no more batches in the printer.
~XJ99 636,656,676, 686,SNAP
This command specifies the number of minimum scans that must be obtained for each
barcode on the tag to pass verification.
~XZ 630,650,960,6X6,SNAP
This command tells the PCL Printer that this is the end of the format layout description.
This command must be sent after the description of the last field.
~XU_ 6X6,SNAP
This command allows additional features to be added by replacing the _ with the
following;
B9 – Barcode Exclusion SV100 Scanner Only
This command allows for specified barcodes on the tag NOT to be verified.
This command is ONLY valid with the SV100 verifier. The barcodes
can be excluded by replacing the 9 with the following;
0 = Exclude none
1 = Exclude UPC-A, UPC-E, EAN-8, EAN-13
NOTE: This command is used by the SNAP printers to emulate
the font engine used in the 6X6 printers. If the printer type
specified in this command is not a SNAP printer, the printer
will add intercharacter spacing to text field to emulate as
closely as possible the same label printed on a 6X6 printer.