Avery Dennison PCL - Manual (Page 47)

PAXAR PCL Reference Guide •••• 45
Special Codes for Special Symbol Information
~YH9 Reserved for Future Printers
This command specifies the expansion multiple for the special symbol in the horizontal
direction.
~YV9 Reserved for Future Printers
This command specifies the expansion multiple for the special symbol in the vertical
direction.
~YT99 960
This command specifies the special symbol type. The 960 has the following special
symbol types.
Type Description
1 Trademark symbol (Tm)
2 Registered symbol
3 10pt Fractions
4 12pt Fractions
5 Size Symbols
6 Centimeter symbol (cm)
~YR9 960
This command specifies how the field will be graphically placed on the tag. There are
four possible ways to place the field's image on the tag. The DIRECT option is the
default and will print the image directly, as it was created. However, when part of the
image or the entire image is coincident with any part of a previously printed image, the
two field images will be compared in those areas where they are coincident.
The DIRECT option is specified by a 0 in the command. The dot will remain on only
when it is on in the last mapped image for that same dot position.
The AND option is specified by a 1 in the command. The dot will remain on only
when it is on in both images for that same dot position.
The OR option is specified by a 2 in the command. The dot will remain on if the dot is
on in either or both images for that same dot position.
The XOR option is specified by a 3 in the command. The dot will remain on only
when it is on in one of the images - but will not be on if it is on in both images for
that same dot position.
The INVERSE option is specified by a 3 in the command. The dot will remain on only
when it is off in the last mapped image for that same dot position.