Avery Dennison PCL - Manual (Page 37)

PAXAR PCL Reference Guide •••• 35
~BK9999 630,6X6,SNAP
This command controls the vertical movement of the system digit and the check digit of
a UPC barcode. The movement is performed in reference to the barcode. The system
digit and check digit always start out at the same vertical position as the human
readable information. The value that is placed in '9999' is the distance the system digits
will be moved vertically from the starting position. This command does not apply to the
GS1 Databar barcode types.
Compatibility Notes:
630, 650 For these printers the resolution or smallest increment is 4 thousandths.
6X6,SNAP The actual resolution or smallest increment is 1/dpi of the printer.
~BR9 630,650,6X6,545
This command specifies how the field will be drawn on the label. There are four
possible ways to place the field's image on the tag. The DIRECT option is the default
and will print the image directly, as it was created. However, when part of the image or
the entire image is coincident with any part of a previously printed image, the two field
images will be compared in those areas where they are coincident.
The DIRECT option is specified by a 0 in the command. The dot will remain on only
when it is on in the last mapped image for that same dot position.
The AND option is specified by a 1 in the command. The dot will remain on only
when it is on in both images for that same dot position.
The OR option is specified by a 2 in the command. The dot will remain on if the dot is
on in either or both images for that same dot position.
The XOR option is specified by a 3 in the command. The dot will remain on only
when it is on in one of the images - but will not be on if it is on in both images for
that same dot position.
The INVERSE option is specified by a 3 in the command. The dot will remain on only
when it is off in the last mapped image for that same dot position.
Compatibility Note:
630 These printers support DIRECT, AND, OR, and XOR.
650 The 650 only supports DIRECT, OR, and XOR.
6X6,SNAP These printers only supports DIRECT, OR, and INVERSE.
~BG9 650,6X6,SNAP
This command allows the format of the HRI Segmentation to be specified. The 9 in the
command would be replaced by a segmentation type number from Appendix A. This
command does not apply to the GS1 Databar barcode types.
~BM_ 6X6,SNAP
This command specifies the option to be used on the selected barcode. Not all options
apply to all barcodes. The options are as follows:
R99 Wide to narrow ratio of the barcode. The only applies to variable length barcodes
such as Code 39 and Interleave 2 of 5 barcodes. The valid values that should