Avery Dennison PCL User Manual
Page 35
PAXAR PCL
Reference Guide •••• 33
~BH9999
630,650,6X6,SNAP
This command specifies the height for the barcode bars. The height is described in
thousandths of an inch. For example: If a barcode is to be 3/4 of an inch in height the
command would be ~BH0750. This command does not apply to the GS1 Databar
barcode types.
Compatibility Notes:
630, 650 For these printers the resolution or smallest increment is 0.0042”
(011mm).
6X6,SNAP The actual resolution or smallest increment is 1/dpi of the printer.
~BW9
630,6X6,SNAP
This command specifies the module width for a barcode (also called the expansion).
The module width is the size of the narrowest bar in the barcode in pixels. The '9' in
this command is the multiple of the narrowest bar.
Compatibility Notes:
630, 650 For these printers the resolution or smallest increment is 0.004”
(0.1mm).
6X6,SNAP The actual resolution or smallest increment is 1/dpi of the printer.
~BX9999
630,6X6,SNAP
This command specifies the length of the Barcode guard bars. This command allows
the guard bars of the barcode to be extended down around the human readable
information. The '9999' of this command is the size of the guard bars in thousandths of
an inch. This command does not apply to the GS1 Databar barcode types.
Compatibility Notes:
630, 650 For these printers the resolution or smallest increment is 0.0042” {0.11mm).
6X6,SNAP The actual resolution or smallest increment is 1/dpi of the printer.
~BC
630, 650,6X6,SNAP
This command specifies that a check digit should be calculated for the barcode. This
command does not apply to the GS1 Databar barcode types.
Note: If the check digit calculation command is used then the data string that is sent for
this field should not include a check digit.
~BZ_
630,6X6,SNAP
This command specifies where the Human Readable Information (HRI) should be
printed in reference to the barcode. Using T places the HRI on the top of the barcode,
using B places the HRI on the bottom of the barcode. This command does not apply to
the GS1 Databar barcode types.
~BA99
630,650,6X6
This command specifies the text font that should be used for the Human Readable
Information (HRI). A selection of zero for the font turns off the HRI. The values for
'99' are located under character fonts in Appendix A. Code page 437 is used for the
HRI of a Code 128 barcode. This command does not apply to the GS1 Databar barcode
types.