Avery Dennison PCL - Manual (Page 21)

PAXAR PCL Reference Guide •••• 19
2 = Exclude Code 39
4 = Exclude Code 128, EDI Code 128
8 = Exclude Interleave 2 of 5
16 = Exclude Code 93
To exclude multiple barcodes, replace the 9 with the sum of the values
designating the barcodes to exclude.
Example: To exclude code 39 and Interleave 2 of 5, add the 2 and the 8
together and the command would be ~XUB10.
C9 – Future Expansion
S9 – Security Feature
This command indicates that the batch is a secure batch. The printer will
maintain a count of the number of tags actually printed and return that count to
the host upon request. See Appendix F Secure Batch Feature for details. The 9
will be replaced as follows:
0 – Disabled (default if command is not present)
1 – Enabled
R999 - RFID Read Power SNAP 700RFID
This command specifies the read power to be used when reading an RFID
transponder embedded in the label. If this command is not present in an RFID
format, the printer’s default read power setting will be used.
W999 - RFID Write Power SNAP700RFID
This command specifies the write power to be used when writing to an RFID
transponder embedded in the label. If this command is not present in an RFID
format, the printer’s default write power setting will be used.
A9 – RFID Signal Adjust SNAP 700RFID
This command specifies the Signal Adjust level to be used when writing to an
RFID transponder embedded in the label. If this command is not present in an
RFID format, the printer’s default signal adjust setting will be used.
X9 – RFID Write Retries SNAP 700 RFID
This command specifies the number of write retries to be used when writing to
an RFID transponder embedded in the label. If this command is not present in
an RFID format, the printer’s default Write Retries setting will be used.
P99 – RFID Protocol SNAP 700RFID
This command specifies the RFID protocol to be used for the label. If this
command is not present, the printer’s default Protocol setting will be used. The
99 is replaced by the protocol number. As of this writing, the following
protocols are available:
1 – Class 1 Gen 2
2 – Class 1 Gen 1 96 bit EPC
NOTE: This command does not allow the exclusion of specific
barcodes, only barcode types. For example, if a label contains
two Code 128 barcodes, excluding Code 128 barcodes will
stop the verification of BOTH Code 128 barcodes