Artesyn Centellis 2000 Shelf - DC Installation and Use (June 2014) - Manual (Page 151)

Chapter 11
Centellis 2000 Shelf - DC Installation and Use (6806800G45F) 151
Software
11.1 Overview
The following sections provide information that you need after you have successfully installed
the hardware.
11.2 Software Requirements
The shelf components are delivered with the software installed.
Section Description
Software Requirements on page 151 This section contains information on which software is
installed on the system components and what tools can be
used for software upgrades.
Blade Insertion and Extraction on page
153
This section contains information about the steps carried
out by the software when a blade is inserted or supposed to
be extracted.
The information in the following subsections assumes that you have set the shelf address on
both MF105 shelf managers to the same value.
Table 11-1 Software Available on Shelf Components
Component Software
ATCA-MF105 IPMC firmware
Payload:

Boot loader (Uboot)
 Linux kernel
 Initial ram disk
Fan tray IPMC firmware