Artesyn Centellis 2000 Shelf - DC Installation and Use (June 2014) - Manual (Page 142)

DHCP Configuration and Network Boot
Centellis 2000 Shelf - DC Installation and Use (6806800G45F) 142
Example:
/tftpboot/pxelinux.cfg> ln –s default.7150 01-00-80-42-18-
34-a0
9.2.2 Preparing a DHCP Server for Network Boot
Install a DHCP server on the host computer and configure it as follows.
Preparing a DHCP Server for Network Boot
To prepare a DHCP server, proceed as follows:
1. Adapt the DHCP configuration file /etc/dhcpd.conf. The following snippet
shows a DHCP configuration for two boards with fixed MAC to IP address
assignment and two network interfaces each. Fixed assignment means that a
specific client will receive the same IP address at each issued DHCP request.
subnet 192.168.9.0 netmask 255.255.255.0 {
default-lease-time 43200;
max-lease-time 86400;
// address of the server from which to upload the sources
// (here the tftp-server)
next-server 192.168.9.55;
group {
// configuration for Board 1 - Interface 1
host board_1_1 {
// MAC Address of the board received in the dhcp-
request,
// e.g.
hardware ethernet 00:80:42:26:79:9e;
// fixed IP address which will be assigned to the client
// according to the network addressing scheme
fixed-address 192.168.9.111;
// initial boot file which is to be loaded by the client
filename "pxelinux.0";
}