AMETEK MX CTSH - Manual (Page 58)

California Instruments Revision H 58
User Manual MX Series CTSH Compliance Test System
3.9 AC Source Control Software Installation
If the CTS system you purchased contains a California Instruments AC power source, it will have included
additional AC source control software as well.
Note: The AC source control software is not required to perform harmonics and flicker tests. It is required to
perform any of the IEC 1000-4 tests however. This software is supplied with its own user manual and
we recommend you familiarize yourself with this user manual also when electing to use the AC source
control software.
The AC source control software is supplied on CD ROM CIC496. Select the MX Series using the installer
program to install the MXGUI program.
To install the AC source control software, proceed as follows:
1. Insert the CIC496 CD-ROM in the PC's CD-ROM drive. If the drive is configured for autoboot, the CI
CD-ROM Browser program should pop up on screen. If not, run the SETUP.EXE program.
2. In the left window of the CD browser, locate the AC Source series for the AC source supplied with the
CTS system.
3. Click on the Programs Tab on the right and select Windows 32 bit.
4. Click on the Install button at the bottom center to run the setup program.
5. Follow the on-screen prompts of the installation program.
6. The setup program will now run and display a dialog box that shows the default directory for the AC
source control software that is MXGUI on the current drive. At this time you can accept the default
directory by clicking on the OK button or enter a different directory. If the directory you enter does not
already exist, it will be created.
7. At the end of the installation process, a message will be displayed indicating the installation is
complete.
8. You can now remove the CD-ROM.